Search the Community
Showing results for tags 'AUD'.
Found 5 results
Time Left: 9 days and 34 minutes
As title suggests i'm after a polo 6n2 engine and interior loom for a 1.4 8v AUD. Has to be a pre canbus model so 2000 and before. I dont want any cut looms as it's for an engine swap on my lupo. Also might be in need of an immobiliser, key chip, and engine ECU from the same car if a deal can be made. Thanks X
I'm planning to swap my 1.0l 8v AUC lupo engine out for a 1.4 8v AUD engine. My ecu and engine is an earlier model that only has one lambda. my question is which model ECU's use just the one lambda, guessing it's going to be an earlier one the same as I already have now for my 1l, but there seems to be quite a few variations. Thanks x
Does anyone know what normal compression should be on the polo 1.4 MPI 8V AUD engine ? I have 3 cylinders around 125PSI and another at 160PSI odd Im aware some engines use this technique of having a higher compression cylinder but it seems very odd ?
charliestg posted a topic in Engine, Transmission and ExhaustHi guys, Can anyone help with a troublesome EML fault reader says Cylinder 2 misfire *intermittent* and multiple cylinder misfire *intermittent* I have changed the following: Spark plugs, HT leads and coil pack Fuel filter air filters (while I was in there might as well) Checked: run cleaner through system, and buzzed all ignition bits. compression test with the results being 125psi for cylinders no#1,2,4 and 175psi for no#3. checked camshaft for wear, which looked and felt smooth and tidy. the main issue is refusal to start when cold, I have to press accelerator to get her going, and at idle the engine management light flashes and goes solid if I do not start moving (sporting the above faults). I've hit a wall so far, any insight would be appreciated :)
Guys I need some help; I have found that I require a new crank shaft position sensor on my 6n2's AUD engine.Does anyone know where it is located, how to get to it and how to remove it? Any Advice on where I could get one that is of good quality would also be appreciated along with any pictures that could help describe its location Cheers, Luke