To improve security of our users, we have changed the way you sign in. From today, you will need to use your EMAIL ADDRESS, and not your 'display name'. ×
Notice to Hotmail/Gmail & BT Internet users - Please check your SPAM/JUNK folders for our emails. Please add our email as a contact to your email account.
To improve security of our users, we have changed the way you sign in. From today, you will need to use your EMAIL ADDRESS, and not your 'display name'.
Search the Community
Showing results for tags 'shaking'.
Hi All I hope someone may shed some light into what is going on with my 2014 1.2tsi 16v CJZC Polo. 41k miles. 1) When I start the engine from cold - it behaves fine,.... i.e. slightly higher idle for a brief moment, then quickly settles perfectly on +/- 650rpm 2) When I start the engine warm-hot, ....after some journey, ...it also behaves absolutely fine. (same as above) 3) BUT when I start the engine +/- 4hrs after stopping, ...it will start with a higher rpm (approx. 1200) then within the next minute or so, will slowly go down and eventually settle on 650rpm. During this settle-down time the car tends to shake ... and IF I drive it during this time, it sounds throaty. I believe it must be temp related, because on a hot sunny day, this "goldilocks" hesitation zone is longer, i.e. around 6hrs after stopping,.... and on a very cold day it is shorter, i.e. around 2.5hrs. Any other time,... earlier or later than this "goldilock" zone causes NO probs. and the car idles perfectly immediately. Recently my O2 sensor2 died (after cat) so I replaced with the approved Bosch (long cable) and reset the fault codes via (limited) diagnostics - and for some time this hesitation problem seemed to be slightly less, .....but now it's the same as before. I fitted the new after-cat O2 sensor around 2 months ago. I would like to ask what might be causing this limited starting hesitation... anyone else have or know about this prob ... and what to do ? Maybe? pre-cat O2 sensor, coolant temp sensor, temp sensor for fuel pressure,.. or something else be the root cause ? I bought the car new ( in 2014 ) and this issue has only shown itself since needing to start/stop after around 4hrs !! (on a normal day) Thx in advance for any tips.
Hi guys, I own a 6n2 1.0 Polo and I think I have a potentially expensive problem. Since the last few weeks, Ive noticed everytime I press the clutch in and out, I hear a faint *clunk* (always happen when releasing the pedal), regardless of where the gear stick is. Now its stopped with another problem. Everytime I drive, my car always jerks regardless of whether I have my foot in the gas. It turns out, my car always jerks at low rpm and stops jerking when I drive with the revs over 2000 rpm. When Im stationary, it doesnt jerk and the engine idles fine. When I recorded my engine revving upto redline, the engine remained tamed in its engine mounts (didnt move lol). When I drive inbetween the jerking range, and I press the clutch and coast. The jerking stops. I was also told that my cv boot or joint or gaitor or whatever the black rubber thing that my axles are connected to is called, its ripped on both sides with small leaks. So whats the potential cause of this? Please dont say its the clutch. Please say its just low transmission fluid.