Skip to content

6n front speaker wiring

Featured Replies

So I've got this 6n, and its got 4in speakers in the dash and 6.5in speakers in the doors, aftermarket ones which are two-way and three-way respectively.

Both are linked to the front channels,which i may change. I may have the dash speakers as the front channels,and the door speakers as the rear channels.

Anyway,in the dash there are four speaker wires coming out the main loom. They're twisted together into a pair,and connected to the single coil dash speakers. The cables are surprisingly thick.

These speakers work fine,but are stealing from the ones in the doors (thinner cables here). So 90% of the sound/volume is from the dash,making it sound a bit lame.

The big door speakers then are very quiet,much louder with the dash speakers disconnected.

So something is wrong,if they're fighting.

I'm getting close to abandoning the loom altogether,and re-wiring it all as a four channel set-up. The HU has plenty of outputs,so i can always put externally amplified speakers in the back at a later date.

But id rather get it working with the loom already there.

Anyone know the issue here? Or know what routes I'm best to take with it?

  • Replies 3
  • Views 1.7k
  • Created
  • Last Reply

Top Posters In This Topic

This is the standard wiring set up

Can't see the diagram as I'm on my phone but I'm pretty sure the standard loom uses the tweeters in the dash with the aid of a capacitor as some sort of high pass filter, the wiring then going to either door to supply the woofers. Although I was under the impression they were wired in parallel, however I imagine the smaller dash speakers will go a lot louder with the power they're getting which would explain it.

Without proper crossovers I would suggest running some wire from the rear outputs of the headunit and splice into the door wiring where it meets the tweeters, using the headunit to set the levels and possibly low/high pass filters, think this is quite a common choice of people who want to upgrade the speakers and use the headunit to power them. This is probably the easiest and cheapest way of doing it.. Although I'm expecting to be corrected soon, like I say after 10 mins or so of cursing I broke out 10m of wire and re did the lot as my amplifier was in the boot anyway.

Edited by AMD_Man

  • Author

Thanks for that lads,it figures.

Got a few metres of some fat Cambridge Audio house speaker cable left,think I'm gonna just re-do the four channels in that and discard the Polo speaker loom altogether.

Create an account or sign in to comment

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.