Skip to content

Mk2 buying advice please

Featured Replies

Hello, I'm brand new here looking for things to look out for on a mk2 1984 1l 4speed as I've got a viewing, it was around 100k on the clocks. How much should I part with too? Not show condition by any means but is mot'd till sept 2012.

I did search first but no returns on this subject. Thanks people.

Daz, Essex.

  • Replies 14
  • Views 1.1k
  • Created
  • Last Reply

Top Posters In This Topic

if it has plastic arch trims, check underneath them for rust. also the battery tray may be rusty

theres a thread in the FAQ with common problems

Rust and some more rust. Wheel arches and battery tray mainly. So 100k miles, 1litre with a 4 speed and not in show winning condition? Probably not worth that much. How much are they asking for?

'84 cars are rarely terribly rusty, but trim wear can be thorough as the foams/vinyls are so old, especially with that mileage. Poor running from neglected points ignition, and shocking brakes, compliment wooly steering from worn steering column link bushes.

Later spec replacements are all reasonably plentiful thanks to sites like this, if it's a desirable solid early shell it'll stay solid as they used such good metal, so it's worth looking past grazed bumpers or torn door trim for a good early shell.

^ So true, my 1982 Polo is so far proving the most solid Polo I have ever owned - Especially compared to the 1998 car I'm taken the engine out of where both sills and rear arches have gone.

  • Author

For one cheers for the advice, it seems pretty tough with body work needing touching up but I was after a small project anyways. The choke and idling needs adjusting other than that just tidying up. Surprisingly nippy for 1l too I paid £500 which I was happy to part with with the long mot and tax too and already lowered 60+.

Cheers for the advice guys.

Sounds a goodun, pictures please :-D

  • Author

I shall sought some out for you guys soon, is there any online shops that is good for most parts in and out? And any decent dismantlers that I should know about.

'84 cars are rarely terribly rusty, but trim wear can be thorough as the foams/vinyls are so old, especially with that mileage. Poor running from neglected points ignition, and shocking brakes, compliment wooly steering from worn steering column link bushes.

Later spec replacements are all reasonably plentiful thanks to sites like this, if it's a desirable solid early shell it'll stay solid as they used such good metal, so it's worth looking past grazed bumpers or torn door trim for a good early shell.

What year did they stop using the better metal? This is a early spec mk2 and theis is just a snap shot of what I had to deal with... The boot lid for example had rotted both inside and out and I'm surprised it managed to hold the screen in

IMAG0534.jpg

IMAG0548.jpg

was that hidden under an arch trim? :o

  • Author

polo2.jpg

polo1.jpg

polo.jpg

I was also very impressed with the 1.0l 4 speed performance as i was expecting it to be useless, which i think explains the brakes pretty well atm lol. Loving it though so fun.

Looks like i found a goodn however i think i broked her today please look at the below thread link if you could help that'd be amazing.

#http://www.clubpolo.co.uk/forum/index.php?showtopic=281889

Cheers

What year did they stop using the better metal? This is a early spec mk2 and theis is just a snap shot of what I had to deal with... The boot lid for example had rotted both inside and out and I'm surprised it managed to hold the screen in

IMAG0534.jpg

^^ That'll have been a D-reg! Betcha! :lol:

Not the most common MK2 these days, the '87..

my c reg one that i am scrapping is ROTTEN hahah!. rusted in the fuel filler flap, and even rusted INSIDE the car where the fuel filler flap is

places I've found rust on mine so far

battery tray, front where the mounting stud is and the rear where the spot welded metal support is.

if left, flaking rust and water will collect in the footwells and will normally rot on the inner sill to floor join.

the rot can also extend into the inner wing, and the wings can rust and the bottom near the door which normally leads to rust on the bottom on the lower sill

rear chassis leg mounts, particularly the drivers side due to the filler neck location, crud collects there and gets damp, rotting through the metal. the underseal is usually holding this location together

inside this panel there is a metal breather pipe, which often rusts and flakes, the flakes sit at the bottom of the sill and rust it from the inside out.

arch trims and lower sill trims can hide horrors so worth having a feel behind them for crispyness

inside of the strut tops front and rear, front panel can rust via stone chips, dinks etc.

lower rear valance corners can go, as well as the flaky underseal on the rear chassis legs up to the rear axle mount

spare wheel well is a common place for rust as water can get in through poor boot and rear light seals.

wet rear drivers and passengers floorpans is usually down to no or torn door membranes, water is sat here will eventually eat away at the floor, usually notable at the front seat mount area first.

and anywhere else where theres exposed metal for whatever reason (dinks etc)

all of its easily sorted if you can weld or know someone who can and have the space, time and motivation!

  • Author

Mine is a C reg and tbh its pretty good it has surface rust in places but nothing around any structual points of even hidden under the bumpers or brackets. there were no arches on it so i guess thats a plus.

Create an account or sign in to comment

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.