Skip to content

Mk2 Front Seats

Featured Replies

Many moons ago I re-trimmed the front seats of from my 1st Polo in leather to fit to my 3rd Polo (long story).

This left me with the original seats surplus to requirements. I recently stripped them down to throw them away responsibly (metal in metal skip, foam in another etc) plus I thought someone might be able to use the original black & white check material for repair patches on their own seats.

This material seems to be damaged quite often but comes up beautifully when washed and is probably not available anywhere.

Anyway the following pictures will show the strip down procedure and now that the seats are boken down posting would be easier if they were to be sold. The only tricky bit is getting the plastic tubes fof the head-restraints out of the seat frame to remove the seat-back cover fully. They have four prons at the bottom which I compressed by pushing a suitable sized rings spanner against them which enables you to push them back through the steel casing

I was tempted to re-trim them to have another set in velour as this would be pretty easy compared to hand-stitching leather like I did before but probably best not to start another project :?

P1000665.jpg

one dirty passenger side '84 Polo seat

P1000667.jpg

backs are more easy to clean

P1000833.jpg

driver's seat always in worse condition

P1000834.jpg

this bolt holding seat belt bracket needs to be removed

P1000835.jpg

gives access to clip which can be levered offcolor"

P1000836.jpg

same on other side then the plates can be splayed out and seat back removed from base

P1000837.jpg

to remove cover from base loosen this wire which hooks behind the seat base rear legs

P1000666.jpg

with the wire loosened off and a couple of plastic clips pulled out the skirt is slack enough to pull up

P1000839.jpg

the cover can then be unfolded and access gained to theses wire rods which hold cover to wires embedded in the foam

P1000840.jpg

there are 3 in total

P1000838.jpg

foams simply sit on top of bases and are of very good quality

P1000843.jpg

why is my driver's seat much lower at front than passenger one?

P1000842.jpg

I guess the car was once driven by a very heavy person as the seat pan has cracked away from the frame in several places

P1010330.jpg

this picture shows how front of seat pan has split and sits down very low

P1000672.jpg

bottom of seat-back cover is fasten by these metal spikes

P1000844.jpg

bend them back

P1000673.jpg

then pull off seat tilting mechanism plastic lever and escutcheon

P1000674.jpg

cover can then be pulled right up to top by compressing the wings slightly

P1010325.jpg

getting cover off is not easy as the plastic tubes click twice into the top of seat frame inside the box section

P1010326.jpg

part no.

P1010327.jpg

passenger seat is pretty much good as new underneath

P1010328.jpg

driver's seat slightly damaged here

So that's the seats broken down into their component parts. Think the next thing I'll do is wash the material. I did this with the original material when I re-trimmed the back seat and it looked fantastic but must be prone to getting dirty as there is so much white in it.

Edited by foy9999

  • Views 1.3k
  • Created
  • Last Reply

Create an account or sign in to comment

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.