Skip to content

Paint problems?

Featured Replies

I've got a red 1996 6n and wanted to know if there is anything i can do, i cant afford to do anything major like a respray so what other options is there?

the only problem is it has faded quite bad theres like pale patchs on the bonnet and roof and a few on other bits, anything you can recomend to get her shining?

also theres a crack under the taillights each side straight down to the bumper on both sides? i was thinking of fillering it and spraying it with a rattle can, thats what brought this along if i order the paint from volkswagen its gona be the colour it was when it was new isnt it, and well it doesn't look new anymore so I'm gona have a bright red patch on a pink car (its not really pink).

so should i get it mixed do you think?

also what kind of filler should i use if anyone can help with that too. thanks :)

any advice is welcome :)

Edited by richhasbigtits

  • Replies 20
  • Views 2.5k
  • Created
  • Last Reply

Top Posters In This Topic

Posted Images

Try giving it a bit of colour restorer then a good polish mate :).

  • Author
Try giving it a bit of colour restorer then a good polish mate :).

Thanks :)

Try giving it a bit of colour restorer then a good polish mate :).

Thanks :)

Did wonders for my white Polo mate, removed all the sorta dirt you can't get off with just a sponge clean, bodywork now feels smooth again :).

  • Author
Try giving it a bit of colour restorer then a good polish mate :).

Thanks :)

Did wonders for my white Polo mate, removed all the sorta dirt you can't get off with just a sponge clean, bodywork now feels smooth again :).

what do you think about the rattle can job though? theres a few other patchs too where the guy who had it before me has ripped the paint off it scraping stuff, would you buy a can of the original paint and just spray over it then paint restore the rest of the car ?

If it's only faded rather than damaged get the car mopped that'd should bring out the full red again and just keep on top of sealing the paintwork :) Reds a b*tch to look after compared to other colours at least.

as for the crack is it paint crack or actual bumpers cracked? If it's only a tiny crack you may be able to get away with just using a high build paint primer and then painting over the top. If it's badly cracked then just get some easy sand bodyfiller.

IMO i'd get your colour mixed, go to a proper paint place as they'll have a decent set of colour cards you can best match to your paintwork as you'll find theres probably 3-4 shades of one colour

HTH :)

  • Author
If it's only faded rather than damaged get the car mopped that'd should bring out the full red again and just keep on top of sealing the paintwork :) Reds a b*tch to look after compared to other colours at least.

as for the crack is it paint crack or actual bumpers cracked? If it's only a tiny crack you may be able to get away with just using a high build paint primer and then painting over the top. If it's badly cracked then just get some easy sand bodyfiller.

IMO i'd get your colour mixed, go to a proper paint place as they'll have a decent set of colour cards you can best match to your paintwork as you'll find theres probably 3-4 shades of one colour

HTH :)

thanks mate, its not the bumper its like just under the lights where the wing comes around the back sort of? i dont know much of these technical words lol, its not a big crack really about 3 inchs long few mm wide and not that deep its sort of a split but not all the way through, hard to explain ill get some pics up when i get around to doing it,

as for the paint i was going to take the petrol cap in to match the paint too, but can you get paint mixed into a a rattlecan or would i need to borrow someones spray gun :\ ? thanks

  • Author

haha just as i was looking for a picture of the back of a car so i can draw where the crack is, i find a picture to draw on and notice it looks like this car has had a crack in the same place, you see where i mean? just under the lights

post-25323-1255469468.jpg

Edited by richhasbigtits

  • Author

ps sorry whoevers car that is i just looked through galeries and this is first one that came up :D

You'll find that every 6n has that crack as it's meant to be there, i think it's a draining point for water or somthing if iirc.

The crack isnt supposed to be there, there is like a sealant type stuff in the gap between the rear wing where it comes around the back and the little bit under the rear light. I think after the years they all crack though. mine, my brothers and my mates are all the same.

  • Author
You'll find that every 6n has that crack as it's meant to be there, i think it's a draining point for water or somthing if iirc.

yeah I'm not sure if they're meant to crack as it doesn't look too healthy but thanks

The crack isnt supposed to be there, there is like a sealant type stuff in the gap between the rear wing where it comes around the back and the little bit under the rear light. I think after the years they all crack though. mine, my brothers and my mates are all the same.

thanks, I've heard of a few that have it but it does look ugly, i want it too look nice and smooth :)

Edited by richhasbigtits

When he said crack I was thinking that he thought it is meant to be smooth.

You can always just get some touch up paint, will make it look alot better for the meantime.

  • Author
You can always just get some touch up paint, will make it look alot better for the meantime.

think i will for now mate was looking for advice on paint and filler and stuff really so i can fix it properly :)

If your using filler over anything thats rusted you need to make sure any rotten metal is removed. If you don't it'll just come back through at a later date. Preparation work is the key with bodywork.

I used to have a red/pink car. Was nevr polished in about 10 years. I attacked t with t-cut and then polish. Tbh, i use G3 cutting compound now, with a damp cloth. Really does bring the colour up, then use a colorued polish too to seal the paint. If you dont do that, it will get really dirty fast. Takes a while mind, too kme 3-4 hours by hand. you could use and electric mop, but if your inexperienced, you could burn right throught the paint!

Although G3 is pricey, its what the professionals use, and will give a superior finish compared to T-cut or any other off the shelf cutting compound.

As regards your paint, if its just a few small areas, i would go to a body shop supplier. They should give you the correct paint, even if the shade isnt exactly the same. You wont notice. I jus did a whole door in a slightly different shade. But one it as cut back with G3 and polished, its impossible to tell the differece. As said before, prep is the key to good bodywork, and taking your time too. Its a fairly expensive thing to do, but well worth it imo

  • Author

ok thanks alot :) any idea what kind of filler and shops it can be bought? and what sand paper shall i use? I'm a right noob with cars :)

  • Author
I used to have a red/pink car. Was nevr polished in about 10 years. I attacked t with t-cut and then polish. Tbh, i use G3 cutting compound now, with a damp cloth. Really does bring the colour up, then use a colorued polish too to seal the paint. If you dont do that, it will get really dirty fast. Takes a while mind, too kme 3-4 hours by hand. you could use and electric mop, but if your inexperienced, you could burn right throught the paint!

Although G3 is pricey, its what the professionals use, and will give a superior finish compared to T-cut or any other off the shelf cutting compound.

As regards your paint, if its just a few small areas, i would go to a body shop supplier. They should give you the correct paint, even if the shade isnt exactly the same. You wont notice. I jus did a whole door in a slightly different shade. But one it as cut back with G3 and polished, its impossible to tell the differece. As said before, prep is the key to good bodywork, and taking your time too. Its a fairly expensive thing to do, but well worth it imo

ok thanks mate

any idea what kind of filler and shops it can be bought? and what sand paper shall i use? I'm a right noob with cars :)

To sort out the pink on your car you really want to give it a proper clean. This will turn the pink back to red.

Look on edition 38 under the detailing section or on detailing world for a proper run down of what to do.

This is what I would do by hand, in simple terms this is what I did on my pink car, with very good results, then it is much easier to keep that way.

Wash

Clay (to remove bonded surface contaminants)

Wash

Paint cleaner (megs step1)

Then paint cleaner (megs step1) yes again, can do it more times if you want.

Polish with autogym SRP (as many times as you want, or can be bothered) I wouldn't recommend more than 50 layers though, i did 3/4 good layers. this may not be the best product for the job, but its one of the better easily available in halfords

Then you need to wax it to seal the polish at least 2 coats possibly more depending on polish.

Another good approach is to use the megs 3 step approach on the car, just do each layer a couple of times at least and take your time

If you can get hold of a rotary this will give much better results, i brought myself a megs GU220 as i am new to this kind of thing.

I guess you need to ask yourself really how much is it bothering you, how much time and money you have got to spend and then what kind of result you really want.

  • Author
To sort out the pink on your car you really want to give it a proper clean. This will turn the pink back to red.

Look on edition 38 under the detailing section or on detailing world for a proper run down of what to do.

This is what I would do by hand, in simple terms this is what I did on my pink car, with very good results, then it is much easier to keep that way.

Wash

Clay (to remove bonded surface contaminants)

Wash

Paint cleaner (megs step1)

Then paint cleaner (megs step1) yes again, can do it more times if you want.

Polish with autogym SRP (as many times as you want, or can be bothered) I wouldn't recommend more than 50 layers though, i did 3/4 good layers. this may not be the best product for the job, but its one of the better easily available in halfords

Then you need to wax it to seal the polish at least 2 coats possibly more depending on polish.

Another good approach is to use the megs 3 step approach on the car, just do each layer a couple of times at least and take your time

If you can get hold of a rotary this will give much better results, i brought myself a megs GU220 as i am new to this kind of thing.

I guess you need to ask yourself really how much is it bothering you, how much time and money you have got to spend and then what kind of result you really want.

thanks alot, really useful :D dont really understand technical words when it comes to cars and stuff though like megs GU220 :\

Create an account or sign in to comment

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.