Skip to content

Old member, new polo. Buying a 6n Estate...

Featured Replies

Hi all,

As a life long VW nut and owning many a VW including Beetles, Campers and a mk3 Fox Coupe, I have now found myself with another Polo!

I have a new job in the pipeline and will need a daily. It just so happens my old man picked this up in the local auctions for just under £400. He will sell it to me for what he paid for it but it has a few issues.

Its a 1999 6n Estate with a 1.6petrol. Its pretty well specced with roof bars, towbar, elec windows, mirrors and sunroof. Its ideal for what I need as I also have my first born just around the corner so it will accommodate all the guff you need to carry around too!

It seems as if the car hasn't been run for a while as the last tax disc found in the car was for 2007 and as a result its running a bit rough. The engine is 'hunting' on idle and there is a bit of black sooty smoke from the exhaust so is that down to the fuel/filter being dirty or something else? I think with a good drink of fresh fuel and a bottle of Redex in the tank it may clear things up a little.

Also on driving it home from the auctions the Clutch cable popped off of its arm. It has been put back in place now but is this a trait of the 6n? will the cable need replacing?

I would also like to ask if there is any love for these beasts, any support, or any guides for fettling them? Are they pretty much the same as the hatch apart from the obvious?

Thanks for reading the above and thanks in advance for any help. As a reward, here are the pics!

P1000559-1.jpg

P1000560.jpg

P1000561.jpg

  • Replies 13
  • Views 3.2k
  • Created
  • Last Reply

Top Posters In This Topic

Most Popular Posts

  • Thanks Andy, the wagon is next in line for a full service after my brothers polo goes in for MOT. We ahave a good family friend that does all our cars and he is a genius so he will hopefully sort it.

If I am not mistaken they are actually based on the Seat Cordoba underneath rather than a 6n Polo.

  • Author
If I am not mistaken they are actually based on the Seat Cordoba underneath rather than a 6n Polo.

Ahhhhh! Ok, so I take it that 6n parts may or may not fit then? That changes things!

  • Author
If I am not mistaken they are actually based on the Seat Cordoba underneath rather than a 6n Polo.

Ahhhhh! Ok, so I take it that 6n parts may or may not fit then? That changes things!

Right, my new potential car, as I have found out is actually a Seat Cordoba Variant. It is quite difficult to find parts for them, and tune them, but with a little bit of adaptation I think I can make it work.

My plans are, Repair and paint front wing, boot release trim and wing mirror. Mop and polish the rest of the bodywork. De-badge the boot and possibly lose the rear wiper. Lower 40mm using a Seat Cordoba kit and fit some G60 steels (my fave!) I like shiny, simple clean lines and low.

Question is, do I bother posting in this forum about this car bearing in mind its is not technically a VW, or do I continue as the thing is still badged Polo?

Opinions please...

keep us updated, its new, its different, i like it

There are other people who have modified them so if you can find one of them I'm sure they would be of great use.

Err yes. But if you are going to lower it, raise the engine. Mine just ate its sump and it's only lowered 40mm on the stock 16" wheels.

  • Author
Err yes. But if you are going to lower it, raise the engine. Mine just ate its sump and it's only lowered 40mm on the stock 16" wheels.

Whoops! Can I ask for A pictures, B info on the lowering kit you used, and C any other hints and tips you have for a 6k?

Regards, Hicksy

pm geodaryl on here.. his looks the nuts

Good news is the 'big block' motors are much more easily accomodated in the engine bay than in a 6N.

Black sooty smoke usually means over fuelling, I'd whack some Redex through it; clean the throttle body out if it's caked up; and then check things like lambda sensor and blue temp sensor if it's still doing it.

Whoops! Can I ask for A pictures, B info on the lowering kit you used, and C any other hints and tips you have for a 6k?

Regards, Hicksy

Your luck to get the roof rails on your car, they are an option that most people didn't seem to spec.

Also seems to have the standard estate problem of the end of the boot blind drooping after years of going back and forth.

This would be my car ;-

http://www.clubpolo.co.uk/forum/index.php?showtopic=273735

Lowering kit was just the one off PhilJ, its a bit stiffy and bouncy but its ok for its job and I am not able / willing to buy hugely expensive suspension for what is my daily hack (it does 80 miles a day).

Tips or Hint for the 6k?

First one would be looks for stuff to upgrade the Seat Ibiza / Cordoba - much easier and more common (and same chassis code as well).

Don't lower it more than 25mm without either a sump guard, a shallower sump or raising the engine (or all three!) unless you fit large wheels - the 14" ones are really far too small!

Give it a bloody good service but if its a big block, be prepared for the HT leads and spark plugs to be a bastard to get at thanks to the VLIM system - I cant even get my plugs out to change them!

In your case I would suggest the service ASAP as if its been towing things it puts a lot more stress on the car.

Not sure what engine yours is, it could either be a big block 1.6 (normally 100bhp) or the small black (in which case it wil be 75bhp and more than likely an AEE or AEA). If is the 75 then you can use the tuning stuff for the 6N with the same engine, if its the big block then tuning options are pretty limited - I know I am looking. So far for the big block all I have found is an induction kit (Jetex one is ugly and I am not paying over £100 for the K&N one "just because" its K&N) and an exhaust system (again not cheap compared to the 6N or Ibiza Cupra ones!). Cams and stuff I am not sure on - possibly small-block ones will work but I wouldnt like to guarantee.

I believe these are based on the 6kv chassis rather than the normal 6n Polo.

If you have the big block motor then surely the mounts should be the same as the GTI Ibiza and Cordoba engines?

I'd be looking down that route if I were you as they are relatively common and I think even the same as the Mk2/3 Golf GTI.

All depends what you want to do though, looks a pretty clean Polo Estate anyway.

  • Author
Good news is the 'big block' motors are much more easily accomodated in the engine bay than in a 6N.

Black sooty smoke usually means over fuelling, I'd whack some Redex through it; clean the throttle body out if it's caked up; and then check things like lambda sensor and blue temp sensor if it's still doing it.

Thanks Andy, the wagon is next in line for a full service after my brothers polo goes in for MOT. We ahave a good family friend that does all our cars and he is a genius so he will hopefully sort it.

Whoops! Can I ask for A pictures, B info on the lowering kit you used, and C any other hints and tips you have for a 6k?

Regards, Hicksy

Your luck to get the roof rails on your car, they are an option that most people didn't seem to spec.

Also seems to have the standard estate problem of the end of the boot blind drooping after years of going back and forth.

This would be my car ;-

http://www.clubpolo.co.uk/forum/index.php?showtopic=273735

Lowering kit was just the one off PhilJ, its a bit stiffy and bouncy but its ok for its job and I am not able / willing to buy hugely expensive suspension for what is my daily hack (it does 80 miles a day).

Tips or Hint for the 6k?

First one would be looks for stuff to upgrade the Seat Ibiza / Cordoba - much easier and more common (and same chassis code as well).

Don't lower it more than 25mm without either a sump guard, a shallower sump or raising the engine (or all three!) unless you fit large wheels - the 14" ones are really far too small!

Give it a bloody good service but if its a big block, be prepared for the HT leads and spark plugs to be a bastard to get at thanks to the VLIM system - I cant even get my plugs out to change them!

In your case I would suggest the service ASAP as if its been towing things it puts a lot more stress on the car.

Not sure what engine yours is, it could either be a big block 1.6 (normally 100bhp) or the small black (in which case it wil be 75bhp and more than likely an AEE or AEA). If is the 75 then you can use the tuning stuff for the 6N with the same engine, if its the big block then tuning options are pretty limited - I know I am looking. So far for the big block all I have found is an induction kit (Jetex one is ugly and I am not paying over £100 for the K&N one "just because" its K&N) and an exhaust system (again not cheap compared to the 6N or Ibiza Cupra ones!). Cams and stuff I am not sure on - possibly small-block ones will work but I wouldnt like to guarantee.

Hey Ross, thanks for your info on the wagons. I believe it may be the 75bhp versions as that what it quotes on the V5 but I will have to double check the engine number when I get it. As for the coilover kit, can you link me to the same PhilJ kit please.

Your car looks great mate and the stance is spot on. Can I ask how you tinted the rear lights? is there a kit or just key, light coverage of spray and the laquer?

I believe these are based on the 6kv chassis rather than the normal 6n Polo.

If you have the big block motor then surely the mounts should be the same as the GTI Ibiza and Cordoba engines?

I'd be looking down that route if I were you as they are relatively common and I think even the same as the Mk2/3 Golf GTI.

All depends what you want to do though, looks a pretty clean Polo Estate anyway.

Cheers for the comments, the car is v.clean and I think it may have been tucked up in a garage or just not driven for a while. The paint need lots of attention and the wing needs replacing but I'm pretty good with the right compound and polishing mop so I'm hoping for good results.

Not sure which kit yours will need (6n style or 6n2 style) so the forum you need is;-

http://www.clubpolo.co.uk/forum/index.php?showforum=85

The lights were tinted by sanding them smooth (they had raised lettering and mould marks on them which I wet-sanded out) and then spraying them with a light tint spray from HellFrauds. I did it the other way to the instructions and sprayed it on the outside of the lights rather than the inside.

As for the stance, I am not quite sure. Still not 100% certain that its right - the rear wheels are tucked in a bit too much as the 6K chassis arches are a failry boxy style (a la the current RS6) so they need a bit more width at the back to look right.

There is a couple more threads that would be a bit better to read than mine;-

http://www.clubpolo.co.uk/forum/index.php?showtopic=107760

http://www.clubpolo.co.uk/forum/index.php?showtopic=241113

Mine's just an old bus that doesnt get that much attention!

Create an account or sign in to comment

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.