Skip to content

JUST ABOUT TO BUY A MK2 POLO BREADVAN.

Featured Replies

Hello!

I think I'm just about to buy a MK2 Polo Bread van 1043cc 4 speed 1989 70k on the clock.

Is there anything to look out for? I've viewed it and I saw no rust in the engine bay, sills, wheel arches nor the boot.

The paint is a little faded in one corner (notorious on red cars.)

It has loads of the cars history.

Its lowered on Phil J springs (good/bad?)

Interior is immaculate.

CONCERN:-----------------------------------------------------------------

When he started the car (first time in 2 weeks.) it started first time, however, there was a ticking/tapping noise in the top end. I saw it could be a broken piston ring or a sticky tappet. The noise dampened after the car had been run for a bit.

Is that somthing I should be concerned about?

Is there anyway I can check its not a f**cked piston ring without dismantling the top-end?

GENERAL------------------------------------------------------------------

Is there anything I should look out for? (problems notorious to Polo Breadvans

I'm going to offere 575, is that reasonable?

  • Replies 26
  • Views 3.2k
  • Created
  • Last Reply

Top Posters In This Topic

Most Popular Posts

Posted Images

Welcome to the club.

Phil J/TA Technix lowering kits are the cheapest kits you can get but they do represent good value, so don't be put off. It's very easy to change the kits if you don't want it low, and if it seems like the suspension is past it's best you can pick up a new kit for £150.

These engines are often 'tappy' in the top end, changing the oil should quieten it down. I wouldn't be too worried (although I haven't heard the car you're buying of course)

If it was a dodgy piston ring then usually you would have a smoky exhaust.

Rust wise the problem areas are the battery tray, and the underside of the fuel filler neck (and in the wheel arch on that side)

Good luck.

  • Author

Welcome to the club.

Phil J/TA Technix lowering kits are the cheapest kits you can get but they do represent good value, so don't be put off. It's very easy to change the kits if you don't want it low, and if it seems like the suspension is past it's best you can pick up a new kit for £150.

These engines are often 'tappy' in the top end, changing the oil should quieten it down. I wouldn't be too worried (although I haven't heard the car you're buying of course)

If it was a dodgy piston ring then usually you would have a smoky exhaust.

Rust wise the problem areas are the battery tray, and the underside of the fuel filler neck (and in the wheel arch on that side)

Good luck.

Thankyou for the help!

I bought it! My first car so I'm very excited.

I'm putting the original wheels on for now as I need the cheapest possible insurance

It's immaculate apart from the front-right (if sat in the car.) panel has a repaired dent. Although its not that noticeable, it's definitely there. If anyone has a red front-right wheel-arch/panel please let me know!

Are there any cheap mods I can do to make it look nicer?

I'll keep you updated!

  • Author

Here she is!

post-915785-0-37898600-1395591653_thumb.

Lovely car.

Yes, very nice actually! Where are you on the south coast?

  • Author

I'm based in Portsmouth!

do you think 575 is a reasonable price?

I'm based in Portsmouth!

do you think 575 is a reasonable price?

I'd say so, you could probably sell the wheels for 250 so the car has cost you 325 :D

Looks very smart, would be a crime to put steel wheels back on it though!

£575 is ok, people have paid more for worse condition cars. 70k is a decent millage. keep it well maintained and you might make a profit when you sell

On those wheels, yeah you got a good price!

  • Author

I'm based in Portsmouth!

do you think 575 is a reasonable price?

I'd say so, you could probably sell the wheels for 250 so the car has cost you 325 :D

Looks very smart, would be a crime to put steel wheels back on it though!

Unfortunately I paid 575 without the wheels I'm 17 so alloys bump up my insurance loads.

(still a decent deal?) It's literally perfect inside and no rust on the outside.

Its got the original steels with the weird dish like hub covers. (they look alright.)

most of the breadys I've seen have had their plastic side trims and boot spoiler plastic removed. Is that just an easy tug job? haha

  • Author

He was asking 650 but I suggested 575 so I can put 6 months tax on her.

I didn't particularly want to rinse him, he was a helpful bloke with a family to feed so I thought it was pretty reasonable.

He was asking 650 but I suggested 575 so I can put 6 months tax on her.

I didn't particularly want to rinse him, he was a helpful bloke with a family to feed so I thought it was pretty reasonable.

Yes, that's still okay, same as what I got for my Mk2F bready. :)

Keep it in good nick and you'll never lose money on it that's for sure.

You haven't done bad, given that someone with a written-off one on eBay which is otherwise the same thinks he's getting at least half that, even though the front panel is wrapped around the chassis leg and suspension mount, indicating structural damage.

Think I'd rather have paid the extra for yours..

Values for these are a bit uncertain to be fair. I still don't think they're worth anything though. It's amazing what you can get for a few hundred quid these days.

very clean looking bready pal!

I'm in the same boat as you, being 17 and facing almighty insurance premiums.

Doesn't sound like you paid a bad amount for her.

What does the front panel damage that you mentioned look like?

Also if you fancy selling the lowering kit, i'd probably be interested!

  • Author

Cheers mush!

Here's a picture of the repaired dent.

I got her home last night so the fun begins haha,

About the lowering kit, I'm not sure if I'd sell it as I'd have nothing to replace it with.

  • Author

Front panel :

post-915785-0-65958300-1395823144_thumb.

  • Author

Got her home now, She's lovely and all is well bar the brakes.

I'm getting a complete brake overghaul, replace one of the wheel bearings and replace one of the fuel tank fittings. After this she should be perfect. (Apart from the above dent.)

I never realised how bloody expensive brakes where...

This makes me want to do some work on my old bready now lol

Just be glad you don't have rear discs, spent about £220 and 5 hours fucking about with the rear callipers/pads/rotors etc on my B5.5 Passat.

  • Author

Yeah only front discs. All in all its going to cost me about £230 for my local classic car mechanic to do.

he's pulling your pants down - prob £30-40 for the parts

brakes are dirt cheap for these , amongst the cheapest you can get really

and anyone with a few spanners and some common sense can rebuild them on the side of the road

id strongly suggest you buy a haynes manual and a small tool kit and start diy'ing things , these cars need a fair bit of tinkering to keep nice and you will need deep pockets to be paying mechanics rates for everything

Edited by steveo3002

  • Author

FEW QUESTIONS!!!

Where can I get a grill like this? 100_0976.jpg

Also, Where can I get some VW mud flaps? Can I put a different model's on?

Does anyone have an original cassette player and fitting?

Thanks guys!

That just a quad lamp grill, you'd find one on here for sale no doubt.

Just keep an eye on the for sale section!

  • 2 weeks later...

Have you got a grill yet? I visited a guy yesterday for some parts and he had one like that for £35, very good condition, in Basingstoke.

  • 2 weeks later...
  • Author

I got one in the post! £26 posted with working hellas and heads. Cracking deal.

Anyone got any tips on finding mudflaps/original cassette tape

Create an account or sign in to comment

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.