hi all just wondering can i buy an of the shelve fitting for the oval end of the eaton m45 charger to enable me to fit my own style of induction kit etc for air intake

i thought that there would be one off a mini or something but it is proving difficult to get any information

I cannot afford any expensive aftermarket systems just yet

hi all just wondering can i buy an of the shelve fitting for the oval end of the eaton m45 charger to enable me to fit my own style of induction kit etc for air intake

i thought that there would be one off a mini or something but it is proving difficult to get any information

I cannot afford any expensive aftermarket systems just yet

best thing to do is get hold of some silicone hose that is 76mm diameter and in a short length then some 76mm pipe and the rest can be done to your own spec see attached pic of my eaton set up hope this helps

beautiful!!!!!!!!! hope mine guna b near this next year !!

can you stretch the hosing over the inlet then, thought it wasnt that stretchy?

My cone fits directly onto the inlet of the charger

what kone is it???

what eaton kit are people using??????

cheers perry

AWT kit well was...

I'm using the one off this engine!

cant wait til i get it all back done tomorrow!

is the silicone hose that stretchy? didnt think you could do that lol, make my life easier

dont think that it is an easy job, you can get silicon hoes that taper down though from a larger bore to a smaller one.

It will need to be a v tight fit though and get your raping skills ready to get it on!

raping skills? i'm wondering what some people get up to lol

haha easy tiger!