Skip to content

police woes :( Camber!?

Featured Replies

bodacceia.jpg
  • Replies 46
  • Views 14.6k
  • Created
  • Last Reply

Top Posters In This Topic

lol and how did it fair in the mot fella did you put it back to standard to get a ticket on it?

I just kept it as it was and The mot said it was ok and just stamped my slip and sent me on my way :D

if thats the case every lowered e30 bm is unsafe too then?

With rear wheel drive and camber like that on the back wheels, yes.

thats about the same amount of contact a standard spare wheel would make

But on both sides of the car.

was it raining at the time? if not - just say, is it raining?

You couldn't pass it off like that, it can rain at any time.

How much do you really know about the isssue? How do you know that camber is unsafe on a rear wheel drive car, have you driven one? The tyres are so wide the contact patch is probably greater than on a standard 4.5" steel. You seem to have a lot of things to say on many technical matters, but if your build thread is any indication of your experience, then stick to advice on cleaning you car.

There is a fairly obvious header at the top of the page:

Dont give out duff advice

New shape BMWs (as standard) have negative camber, 5series and x5s especially. Also 350z have loads of neg camber as standard, are they illegal then?

can't advise on camber, but i was speaking to my mot guy about poke on wheels the other day and he confirmed there is nothing in the mot rules that states the wheel/tyre must be covered by the body work. by all accounts one of the lads he works with got took to court about it, he drives off road type vehicles with no arch above wheel, got off no worries and the coppers got a slippering over wasting the courts time.

not sure if vosa work to a different rule book, but should be alright... least i hope it is as i've just got my 8j's to fit :-D

There is no MOT rule about the tyres having to be covered. However it is covered under Construction & Use laws (which is what the police/VOSA use).

Matt

"What the FUCK is that?" haha! Have seen before, and it is ludicrous!

And the delorian at the end :lol:

Edited by prankstar2003

seriously...mudflaps should cover most of that anyway?...why don't you chuck them on...would be the easier thing to do

You should get pulled over for running camber full stop !

wow, quite a few against camber on here :o

Ohh I'm new btw :)

I don't think it looks all that good tbh, just looks broken, and you'll end up spending all your money on tyres

Camber can look good if used properly, :)

and that video, the guys voice is more gay than the camber, THink hes forgotten hes in Japan, :)

also that red masda :)

Edited by Jonnyboi

not sure if vosa work to a different rule book, but should be alright... least i hope it is as i've just got my 8j's to fit :-D

If you're worrying about poke, then no, you haven't got your 8s to fit.

You seem to have a lot of things to say on many technical matters, but if your build thread is any indication of your experience, then stick to advice on cleaning you car.

:lol:

I just remembered why I dont use this forum much any more!

0.5-1.5 degrees of camber is the max amount of negative camber you should be running to improve handling. The main reason negative camber is used is to increase tyre contact when the suspension is compressed and the geometry has changed, there is a fine line as to what is optimum and it will always be a compromise.

But it is obvious that the reason people on here run silly camber is not to improve handling, but to make the silly wide wheels that were cheaper than the correct size and offset wheels look as though they fit.

In my opinion it is one big "look at me" fail.

It has been bought to my attention that a narrower rear track improves handling on a front wheel drive car. Another thing that seems to get overlooked in the bid for "stance scene points".

The euro stance scene has bored the tits off me. Personally i'd rather have a car that handled nicely, but looked fairly standard, than a bag of shit to drive, that has people looking at it all day long (including the police).

Just my 2p.

Camber can look good if used properly, :)

This is what I'm getting at.. using camber for looks, not for handling. Essentially what may be regarded as "barry boy". Which is what most people on here probably laugh at, thinking they're different.

You seem to have a lot of things to say on many technical matters, but if your build thread is any indication of your experience, then stick to advice on cleaning you car.

Smartest thing in here so far

As for the camber, pointless tbh, i ran it for a while admittedly but it was horrible to drive on. Decided id rather have a car that handled well than one that looked like the rear sus was bust :lol:

ordering my shims tomorrow :thumbsup:

:lol: stop bitching people it's there cars they do what they like and is how it should be if it's not harming any one else why not!

Every time i see a thread on camber, this comes to mind:

bugcamber.jpg

REAL camber, not all watercooled cars' pathetic fail :lol:

:drool:

I asked my dad last night(mot tester) he said he cant fail a car on having too much camber, just pass and advise

He said its the same as when a mk3 came in for mot with 145 tyres on a 9j wheel, he phoned vosa during the test and they said pass and advise..

Edited by R0yaL3

Yeah but if he had any kind of accident the blame would most likley be put on the guy with advisories for stupid tyres and camber.

Create an account or sign in to comment

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.