Skip to content

What Did You Do To Your Polo Today?

Featured Replies

Started work on a new valver bumper this weekend :)

Got it all plastic welded and fillered, then started to sand, soon got bored of that and said it can wait for another rainy day...... looks like ill be sanding tonight :lol:

  • Replies 1.7k
  • Views 82k
  • Created
  • Last Reply

Top Posters In This Topic

Most Popular Posts

  • Took the 6n for a 60 mile drive today, got filmed driving it & I was interviewed for an upcoming TV series "World's Deadliest Drivers". They'll be using my dashcam footage from both of my accident

  • dougstar21
    dougstar21

    This is you Mark: Changed the oil filter today. Changed the spark plugs today. Topped up the screen wash today: Replaced the rear tyres today: That poor engine is never in the car! Ha ha.

  • Well my car has now gone on its own little travels Next time I'll see her she will be outside our house in the USA

Posted Images

Last night .. went to put carbs on .. snapped fuel tpiece .. fuck .. :( lol

Finally! Got round to taking the rear wiper off, it's usually one of the things to be done but I seem to have left it as one of the last, looks Much better now :-D

Took gearbox off, changed flywheel & clutch, refitted box, changed cam, washed it

fixed t piece ...

going tomorrow to get car started hopefully lol

New dizzy cap and rotor arm,

New cv boot

Took arch trims off

Rolled rear arches

Ordered oil and filter, sump gasket sealant and camshaft oil seal ;)

POR-15, POR-15 and more POR-15.

This fucker ain't rusting!

Started refurbing original steelies and looked longingly at my doorcards hoping they would finish themselves? Bottom of the page- sorry its not a massive thread as of yet!

http://www.clubpolo.co.uk/forum/index.php?...p;#entry2416479

THIS:

DSCF8664_zps4fbb7cef.jpg

played around with map sensors to try and cure a problem i have :)

fitted coilovers!

also, cleaned up one side of the bump strip gluey crud haha... took it for a drive.

ordered all red rears and some black vinyl for bits and bobs on the car :)

Just went to get my Miti calipers out of it so i can measure a tyre tread, found a tub of gear oil has leaked in the footwell - interior absolutely honks of gear oil, might have ruined entire interior :(

Removed oil and threw a load of kitchen roll in there until later today. No more carpet for Mikey, but i'll try the jet wash later.

Fitted new water pump, and an entire total of 40mm of stub axle spacers !!

haven't really posted on this for a while

but managed to finish it for its mot,which it passed today :-)

few bodywork bits to address and a new windscreen,then interior goodnesses are happening :-D

sparyed all the rusty parts! then it rained haha

Painted callipers red and started to clean up my steelies of the peeling shite they have all over them with a rotary wire thing on end of drill

Fitted a new windscreen wash pump at weekend too and went and found a near new centre pipe from scrappy for £12 so grabbed that as the old one was fucked.

Hammerd on some trumpets, then, RAGGAGEEE lol love driving in the rain

Gave her a good clean up, checked the battery tray for any rust (perfect), fitted the 'gti effect' red stripe around the bumper and gave her a hoover inside :D

Drove down a country lane and ripped my exhaust off, waiting for the AA is the rain and then watched him bodge it back on

Engine lifted, more <3

POR-15, POR-15 and more POR-15.

This fucker ain't rusting!

Just for a change..... Applied more POR-15 :lol:

Finally managed to make my way to the shed on me crutches, get partially comfy, and put my gearbox together - now ready to put in the car.

Not entirely happy though because it took it's toll on my foot big time, cracked some of the 'plaster' cast (it's more of a composite but not fibreglass), and i've been passed out on the sofa most of the time since. Now high on as many painkillers as i dare.

got it up on ramps and in process of taking plastic sill and arch covers of to investigate mot failure welding ,surprisingly its only 2 little bits (sill inner/outer/to wheel arch (about 3" either side)) was expecting alot more so happy days .get it welded up tomorrow.

Edited by vw1970

Create an account or sign in to comment

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.