My polo is most likely going to be up for sale come the end of February if there is any interest,

I will upload pictures when I have some, available. wanting £1,400 or offers accepted

engine

Rebuilt head- all seals replaced.

media blasted all burs and sharp edges removed to stop hot spots on head.

1.6 ported and polished head.

bar-tek tuning adjustable Camshaft pulley

030AF 1.3 GT 232 camshaft

polished valves,

new hydraulic lifters

new head gasket kit with skimmed head.

Ram air 3 inch induction filter with aluminium intake pipe

oil breather

Performance 8mm Kevlar H/T leads blue

polished rocker cover

facet rotor arm

bosch oil filter

circoli thermostat

new thrust bearing

1.0l GEARBOX for lower ration gear box

good year cambelt with water pump replaced

polished head face

bottom end rebuilt,

polished piston heads

new bearings

bores were honed

new piston rings

lightened and balanced Flywheel remover 1.5KG as too much can damage the crank

4-2-1 stainless manifold cat welded in section between centre section and manifold for MOT reasons

sportex race tube

got stainless steel back box that might want replacing as was damaged when reversed into curb (yes it is that low)

new distributor cap

bosch S3 battery year old

16v front and rear bumpers

clear indicators

HID conversion front lights

heko wind deflectors

New windscreen replaced as damaged during rebuild ooops :)

dark purple tinted windows

badboy bonnet

debadged front grill

debadged boot

white led number plate lights

gear gaitor replaced and gear knob

16v digital interior

if get the right price they will be included in the sale 13 inch deep dish slotted rims two probably need re chroming but still look amazing

the whole car will be sprayed Matte black as vinyl job looks ....

hella rear window spoiler (literally just a lip nothing big or stupid)

bad parts no Speedo working, as wire on loom burnt back but it hasn't bothered me as RPM in 5th every 500 is 10mph roughly but trying to source a replacement loom.

no TAX or TICKET but it was an expensive MOT last year haha so don't see much coming up.

I've got a whole in the floor that I'm going to weld up but might need exhaust looking at a back as said it was damaged and I welded it together in a rush haha no rust on body panels. somethings I'm going to look at before is sell the car anyway but other MOT concern is Light is cracked on farside and HID don't have correct beam pattern so normal bulbs will need to go on for MOT and adjusting. the car is low just managed to get it on a low loader.

that about it thanks

Selling the wheels mate?