Skip to content

average power of clubpolo polos

Featured Replies

Looking round the site, it doesnt seem like many folk are into making their Polos quicker, brakes, suspension and speaks seem to be the way most are heading to fit with the "Low and Slow" theme.

Are there any memebrs who have decent power outputs in their polos? Sort of 150bhp and above?

I'm mainly referring to the older mk1,2 and 3 polos not so muh the newer gti or anything

Cheers

  • Replies 47
  • Views 2.6k
  • Created
  • Last Reply

Top Posters In This Topic

Some of the G40s on here are..and some of the conversions too :unibrow:

There will mainly only be G40's knocking out the 150bhp i think. There is quite a few on the forum that are running that sort of power. In the end these cars are polos and the stock power levels are pretty piss poor. Tuning them to crazy power is also expensive and in some peoples eyes not worth it. Some GT's will be near 100bhp too but apart from mk1, mk2 or mk3 polos rocking a G40 or a tuned 1.4 16v (maybe) there isn't many high powered polos.

Thats why people go for the as you say low and slow. If it was out and out power i am sure that people would be going with a more suitable base car to tune.

I am trying to build the car up as best i can with good suspension, and other components and then make a decision on the power side of things. I have a mk2 carbed 1.3 and unless i change the engine i don't expect to see any silly power from it. Damn fun though.

Their are a few G40 runing that sort of power on the forum. But people incluing me are aiming for 100bhp out of naturally asperated GT's.

oh and welcome

Dan

EDIT: I'm too slow :lol:

Edited by mk3 saloon

...... plus the mk1, mk2, and mk3 can only take small block engines as a conversion unless you start doing some serious modification/fabrication. Was a mk3 with some huge engine mounted in the rear that is silly quick. Plus the mk1 with the VR6 turbo, again silly fast. Like to see a polo with a heavy front mounted engine turn though, would be a disaster.

a couple of mk4 polos with conversions about to. i know that ash mk4 polo is 200bhp+ with a 20v engine and a couple of others about and also a few g406ns about too. couple of vr6 polos around to but not the best coversion imo for a polo. as you say people tend to go for low and slow as conversions are very pricey.

Edited by dhali

I would say there are a few that get up to that level.. but at that power it is reserved to the G40's or major engine swaps. You have to remember that out of the Mk1's,2's and 3's the most powerful car was the G40 (which there arn't to many about now) which at a guess was 112-120bhp and then the GT at 75bhp..

there are loads of non G40 people making the cars 'faster' than standard (me included) but will never get to the 3 digits..

The main point to making a quick car is weight and that's what the earlier polos have to their advantage (prob the only thing :lol:). But if you think that a Mk1 Elise had 120bhp and weighed in at about 850Kg (141bhp/Ton) and GT tuned to 90bhp (quite easy to do with a couple hundred quid... apparently.. :)) weighing in stripped out at 750kg(???) gives 120bhp/ton so not too far behind but a dam site cheaper (but not as good handling) :)

.... so to summarise :lol: ... loads of people making their cars quick but not that many breaking 150bhp... (bar a few of the G40 boys/girls)

Mark...

Sorry for the essay was board at work..

There are a few quick G's around would be intresting to know what the guys running Turbo conversions are running ..

I know of someone doing a Bottom end conversion too that could be rather tasteful .

I'd say there are quite a few mk1,2,3 polos with 150 bhp upwards on here, generally aint the the type of people that shout about it though....... :ninja:

150bhp is pretty simple on a G though isnt it? induction kit, exhaust, chip n remap, toothies and a smaller pulley would comfortably get 150bhp.. my first Gt was 90.3 on the rollers as apposed to 75 standard. all that had was a poloace chip, induction kit and decat with full ss system. my next one had the same chip, induction kit, decat + backbox, and inlet maniflod from a G40 and tbh was about the same... just the manifold moved the power to a different point.

my brothers old G made 131 on the rollers with just an induction kit and some wanky butchered up backbox that was original twin pipes chopped off, plated then single pipe bodged in place. and that was on a car of unknown history, no sign of a charger rebuild in 110k!

and isnt ash 20vt 6n about 350bhp????? its in excess of 300 anyway cos i remeber it topping the rollers at aldon lol

331bhp for ashes mk4.. theres a mk3 mid engine runnin about the same i think? :paranoid:

not a average tho.. lol. ;)

Edited by riskie

well i was on the brink of seling the gti but thought to myself its a nice wee car and I'm gona go to town and make it my own so yesterday i ordered new alloys and coilovers from phil j

next on the list is the G60 disks and caliper carriers

then I'm gona go for the breathing mods, 4-2-1 manifold, induction kit, stainless system and decat then see where i am, id hope that lot would derestrict the engine enough to get me near the 140bhp mark

other than big money i cant think of much else to do to it for more power, i suppose cams and a remap but youd be looking at id imagine 600 - 800 pounds and i cant see myself doing that for another 10bhp

what else could be done to the standard gti to extract more bhp?

331bhp for ashes mk4

WOAHH!!

i didnt know it was 331bhp. thats is immpressive especialy in a polo it must literally fly.

2007-08-13-2053-32.jpg

1.0s FTW!

:lol:

I'll help toby pull the average down

Mk3 GT - 75bhp

Mk2 Coupe - 55bhp

Mk2 Square - 55bhp

Mk1 - 0bhp (no engine!)

:badgrin: :badgrin: :badgrin: :badgrin:

haha thats a really weird shaped graph in comparison to say my GT one!

forgot to mention my first GT had an un setup golf GTI 8v AFM so that probably brought the power down!

and chrisgti- i dunno how the polo engine would respond but for example a saxo VTS cams, remap, induction kit and exhaust will see the naughty side of 160bhp easily, some guys have squeezed excess of 170 out of them, but thats all stock bar the cams and map induction kit n zorst! but then i know the gti's not as performance orientated plus heard people say the rods are quite weak?

haha thats a really weird shaped graph in comparison to say my GT one!

forgot to mention my first GT had an un setup golf GTI 8v AFM so that probably brought the power down!

and chrisgti- i dunno how the polo engine would respond but for example a saxo VTS cams, remap, induction kit and exhaust will see the naughty side of 160bhp easily, some guys have squeezed excess of 170 out of them, but thats all stock bar the cams and map induction kit n zorst! but then i know the gti's not as performance orientated plus heard people say the rods are quite weak?

160 would be about top wack with all breathing mods, cams and a remap on a saxo, i cant see them getting near 170 unless they were on boddies or had some headwork and a wilder cam, my last car was a 106 gti and i had the stainless manifold, full decat stainless system and forced induction kit, ran 146 on the rollers and that was quite strong for a 106, well compared to others with the same mods

be intresting to see what the wee polo will put out :D

there are loads of non G40 people making the cars 'faster' than standard (me included) but will never get to the 3 digits..

Mine does, just, at 103bhp(1.6 8 valve, N/A) but the torque figure is the fun bit at 126lb/ft :lol:

That 1.0ltr graph looks quite funny, but why does it stop at 6k? The bhp hasn't dropped off still climbing by the looks of things

there are loads of non G40 people making the cars 'faster' than standard (me included) but will never get to the 3 digits..

Mine does, just, at 103bhp(1.6 8 valve, N/A) but the torque figure is the fun bit at 126lb/ft :lol:

There is always one!!! :-p:lol:

That 1.0ltr graph looks quite funny, but why does it stop at 6k? The bhp hasn't dropped off still climbing by the looks of things

That's the annoying rev limiter :lol: it stops bang on 6500 rpm

haha thats a really weird shaped graph in comparison to say my GT one!

forgot to mention my first GT had an un setup golf GTI 8v AFM so that probably brought the power down!

and chrisgti- i dunno how the polo engine would respond but for example a saxo VTS cams, remap, induction kit and exhaust will see the naughty side of 160bhp easily, some guys have squeezed excess of 170 out of them, but thats all stock bar the cams and map induction kit n zorst! but then i know the gti's not as performance orientated plus heard people say the rods are quite weak?

160 would be about top wack with all breathing mods, cams and a remap on a saxo, i cant see them getting near 170 unless they were on boddies or had some headwork and a wilder cam, my last car was a 106 gti and i had the stainless manifold, full decat stainless system and forced induction kit, ran 146 on the rollers and that was quite strong for a 106, well compared to others with the same mods

be intresting to see what the wee polo will put out :D

the mk5 gti gearbox wont take too much power......i have a cutsom map, bmc, manifold and exhaust system and I'm on 140bhp

are there any stronger gearbox's thatll go on? say off a mk4 golf or something?

This sort of thread would actually be quite interesting to figure out the average bhps. Can you add a vote to the topic anyhow?

Create an account or sign in to comment

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.